System information

86 | Chapter 3: Configuring Stacking Switches
GS752TXS Smart Switch Software Administration Manual
Stack Port Configuration
To display the Stack Port Configuration page, click System  Stacking  Advanced  Stack
Port Configuration. A screen similar to the following displays.
1. Configured Stack Mode - Specify the operating mode of the port to be either Ethernet or
stacking. The default value is set to stacking.
The following table describes Stack Port Configuration fields.
Detected Code Version in Flash The displays the Release number and version
number of the code stored in flash.
SFS Last Attempt Status This displays the status of last tried stack firmware
synchronisation. “None” is the default value if SFS
has not been tried.
Field Description
Unit ID Displays the unit.
Port Displays the stackable interfaces on the given unit.
Running Stack Mode Displays the run-time mode of the stackable
interface.
Link Status Displays the link status (UP/DOWN) of the port.
Link Speed (Gbps) Displays the maximum speed of the stacking port.
Field Description