System information

40 | Chapter 2: Configuring System Information
GS752TXS Smart Switch Software Administration Manual
7. EUI64. Specify whether format IPv6 address in EUI-64 format. The default value is False.
8. Click Add to add a new IPv6 address in global format.
9. Click DELETE to delete a selected IPv6 address.
10. Click Apply to apply the changes to the system. Update the switch with the values on the
screen. If you want the switch to retain the new values across a power cycle, you must
perform a save.
11. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
IPv6 Network Neighbor
Use the IPv6 Network Neighbor page to configure the IPv6 Network Interface IPv6 Neighbor
Table.
To access the page, click System  Management  IPv6 Network Neighbor. A screen similar
to the following displays.
• IPv6 Address. Specifies the IPv6 address of neighbor or interface.
• MAC Address. Specifies MAC address associated with an interface.
• IsRtr. Indicates whether the neighbor is a router. If the neighbor is a router, the value is
True. If the neighbor is not a router, the value is False.
• Neighbor State. Specifies the state of the neighbor cache entry. The following are the
states for dynamic entries in the IPv6 neighbor discovery cache:
• Reach. Positive confirmation was received within the last Reachable Time
milliseconds that the forward path to the neighbor was functioning properly. While in
REACH state, the device takes no special action as packets are sent.
• Stale. More than ReachableTime milliseconds have elapsed since the last positive
confirmation was received that the forward path was functioning properly. While in
STALE state, the device takes no action until a packet is sent.