System information

282 | Chapter 9: Maintenance
GS752TXS Smart Switch Software Administration Manual
4. To set the selected image as the active image, select the Active Image check box.
Note: After activating an image, you must perform a system reset of the
switch to run the new code.
5. To remove the selected image from permanent storage on the switch, select the Delete
Image check box. You cannot delete the active image.
6. Click Cancel to cancel the operation on the screen and reset the data on the screen to the
latest value of the switch.
7. Click Apply to apply the settings to the switch.
Dual Image Status
The Dual Image Status page displays system images.
To display the Dual Image Status page, click Maintenance > File Management > Dual Image
> Dual Image Status.
The Dual Image Status page shows the following:
• Unit - This displays the unit ID of the switch.
• Image1 Ver - This displays the version of the image1 code file.
• Image2 Ver - This displays the version of the image2 code file.