System information

226 | Chapter 7: Managing Device Security
GS752TXS Smart Switch Software Administration Manual
• ACL Based on Source MAC - Use this to create a ACL based on the source MAC
address, source MAC mask and VLAN.
• ACL Based on Destination IPv4 - Use this to create a ACL based on the destination
IPv4 address and IPv4 address mask.
• ACL Based on Source IPv4 - Use this to create a ACL based on the source IPv4
address and IPv4 address mask.
• ACL Based on Destination IPv6 - Use this to create a ACL based on the destination
IPv6 prefix and IPv6 prefix length.
• ACL Based on Source IPv6 - Use this to create a ACL based on the source IPv6
prefix and IPv6 prefix length.
• ACL Based on Destination IPv4 L4 Port - Use this to create a ACL based on the
destination IPv4 layer4 port number.
• ACL Based on Source IPv4 L4 Port - Use this to create a ACL based on the source
IPv4 layer4 port number.
• ACL Based on Destination IPv6 L4 Port - Use this to create a ACL based on the
destination IPv6 layer4 port number.
• ACL Based on Source IPv6 L4 Port - Use this to create a ACL based on the source
IPv6 layer4 port number.
2. In the Rule ID field, enter a whole number in the range of (1 to 10) that will be used to
identify the rule.
3. In the Action field, specify what action should be taken if a packet matches the rule's
criteria. The choices are permit or deny.
4. In the Match Every field, specify True or False.
5. In the Destination MAC field, specify the destination MAC address to compare against an
Ethernet frame. Valid format is (xx:xx:xx:xx:xx:xx).
The BPDU keyword may be specified using a Destination MAC address of
01:80:C2:xx:xx:xx.
6. In the Destination MAC Mask field, specify the destination MAC address mask specifying
which bits in the destination MAC to compare against an Ethernet frame. Valid format is
(xx:xx:xx:xx:xx:xx).
7. The BPDU keyword may be specified using a Destination MAC mask of 00:00:00:ff:ff:ff.
8. In the Binding Configuration area, specify the packet filtering direction for an ACL in the
Direction field. Valid direction is Inbound only.
9. In the Port Selection Table area, specify the list of all available valid interfaces for ACL
mapping. All non-routing physical interfaces and interfaces participating in LAG are listed.
10. To add a new rule to the ACL based on destination MAC, select the check box next to the
Name field, then click Add.
11. To remove the currently selected Rule from the ACL based on destination MAC, then click
Delete.
12. To cancel the configuration on the screen. Reset the data on the screen to the latest value of
the switch, then click Cancel.