System information

208 | Chapter 7: Managing Device Security
GS752TXS Smart Switch Software Administration Manual
To configure Access Profile:
1. Enter the name of the access profile to be added in the Access Profile Name field.
Maximum length is 32 characters.
2. Choose the Activate Profile check box to activate an access profile.
3. Choose the Deactivate Profile check box to deactivate an access profile.
4. Choose the Remove Profile check box to remove an access profile. The access profile
should be deactivated before removing the access profile.
The Profile Summary field displays the following:
• Rule Type: This is the action to be performed when the rules selected are matched.
• Service Type: The policy is restricted by the management chosen from Drop-down
menu. Possible methods include “HTTP”, “Secure HTTP (SSL)”, and “SNMP”.
• Source IP Address: This is the Source IP Address of the client originating the
management traffic. Fill in the “Source IP address” in the text box provided.
• Mask: This is the Source IP Address Mask of the client originating the management
traffic.
• Priority: This is where the rule is configured. The rules are validated against the incoming
management request in the ascending order of their priorities. If a rule matches, action is
performed and subsequent rules below are ignored. For example, if a Source IP
10.10.10.10 is configured with priority 1 to permit, and Source IP 10.10.10.10 is
configured with priority 2 to Deny, then access is permitted if the profile is active, and the
second rule is ignored.
5. Click Refresh to update the information on the screen.
6. Click Apply to start the certification configuration.
7. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.