System information

Chapter 7: Managing Device Security | 203
GS752TXS Smart Switch Software Administration Manual
To configure the HTTP server settings:
1. Enable or disable the Web Java Mode. This applies to both secure and unsecure HTTP
connections. The currently configured value is shown when the Web page is displayed.
The default value is Enable.
2. In the HTTP Session Soft Timeout field, specify the number of minutes an HTTP session
can be idle before a timeout occurs.
After the session is inactive for the configured amount of time, the administrator is
automatically logged out and must re-enter the password to access the management
interface. A value of zero corresponds to an infinite timeout. The default value is 5
minutes. The currently configured value is shown when the Web page is displayed.
3. In the HTTP Session Hard Timeout field, specify the hard timeout for HTTP sessions.
This timeout is unaffected by the activity level of the session. The value must be in the
range of (0–168) hours. A value of zero corresponds to an infinite timeout. The default
value is 24 hours. The currently configured value is shown when the Web page is
displayed.
4. In the Maximum Number of HTTP Sessions field, specify the maximum number of HTTP
sessions that can exist at the same time. The value must be in the range of (0–16). The
default value is 16. The currently configured value is shown when the Web page is
displayed.
5. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
6. If you make changes to the page, click Apply to apply the changes to the system.
Secure HTTP Configuration
Secure HTTP enables the transmission of HTTP over an encrypted Secure Sockets Layer
(SSL) or Transport Layer Security (TLS) connection. When you manage the switch by using