System information

Chapter 5: Configuring Routing | 157
GS752TXS Smart Switch Software Administration Manual
• Add selected ports to the newly created VLAN and remove selected ports from the default
VLAN.
• Create a LAG, add selected ports to a LAG, then add LAG to the newly created VLAN.
• Enable tagging on selected ports if the port is in another VLAN. Disable tagging if a
selected port does not exist in another VLAN.
• Exclude ports not selected from the VLAN.
• Enable routing on the VLAN using the IP address and subnet mask entered.
• Use the VLAN Routing Wizard page to enter or change router parameters.
To display the page:
1. Click Routing  VLAN, then click the VLAN Routing Wizard link.
2. Select an available VLAN ID from the Vlan ID drop-down menu. The VLAN Identifier (VID)
associated with this VLAN. The range of the VLAN ID is (1 to 4093).
The Ports fields displays selectable physical ports and LAGs (if any). Selected ports will
be added to the Routing VLAN. Each port has three modes:
• T(Tagged) - Select the ports on which all frames transmitted for this VLAN will be
tagged. The ports that are selected will be included in the VLAN.
• U(Untagged) - Select the ports on which all frames transmitted for this VLAN will be
untagged. The ports that are selected will be included in the VLAN.
• BLANK(Autodetect) - Select the ports that may be dynamically registered in this
VLAN via GVRP. This selection has the effect of excluding a port from the selected
VLAN.
3. The address in the IP Address field defines the IP address of the VLAN interface.
4. The address in the Network Mask field defines the subnet mask of the VLAN interface.