System information

152 | Chapter 5: Configuring Routing
GS752TXS Smart Switch Software Administration Manual
1. Click Routing  IP, then click the IP Configuration link.
Table 5-1. IP Configuration Fields
Field Description
Default Time to Live The default value inserted into the Time-To-Live field of the IP header of
datagrams originated by the switch, if a TTL value is not supplied by the
transport layer protocol.
Routing Mode Select either the Enable or the Disable radio button. You must enable
routing for the switch before you can route through any of the
interfaces. Routing is also enabled or disabled per VLAN interface. The
default value is Disable.
Maximum Next Hops The maximum number of hops supported by the switch. This is a
read-only value.
2. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
3. If you make any changes to the page, click Apply to apply the changes to the system.
IP Statistics
The statistics reported on the IP Statistics page are as specified in RFC 1213.
To display the page: