System information

144 | Chapter 4: Configuring Switching Information
GS752TXS Smart Switch Software Administration Manual
5. In the Querier Expiry Interval field, specify the time interval in seconds after which the last
querier information is removed. The Querier Expiry Interval must be a value in the range of
60–300 seconds. The default value is 60.
6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
7. Click Apply to apply the new settings to the switch. Configuration changes take effect
immediately
Querier VLAN Configuration
Use this page to configure MLD queriers for use with VLANs on the network.
To access this page, click Switching
 Multicast  MLD Snooping Querier  Querier VLAN
Configuration.
The following table describes the information available on the Querier VLAN Status page.
Field Description
VLAN ID Specifies the VLAN ID on which MLD Snooping Querier is administratively
enabled and VLAN exists in the VLAN database.
Querier Election Participate
Mode
Enable or Disable the MLD Snooping Querier participate in election mode.
When this mode is disabled, up on seeing other querier of same version in
the VLAN, the snooping querier move to non querier state. Only when this
mode is enabled, the snooping querier will participate in querier election
where in the least IP address will win the querier election and operates as
the querier in that VLAN. The other querier moves to non-querier state.