System information

Chapter 4: Configuring Switching Information | 143
GS752TXS Smart Switch Software Administration Manual
4. Click Apply to apply the new settings to the switch. Configuration changes take effect
immediately
5. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
Querier Configuration
Use this page to enable or disable the MLD Querier Configuration feature, specify the IP
address of the router to perform the querying, and configure the related parameters.
To access this page, click Switching Multicast  MLD Snooping  Querier Configuration.
To configure the Querier settings:
1. From the Querier Admin Mode field, enable or disable the administrative mode for
MLD Snooping Querier.
2. In the Querier Address field, specify the Snooping Querier Address to be used as source
address in periodic MLD queries. This address is used when no address is configured on
the VLAN on which query is being sent. The supported IPv6 formats are x:x:x:x:x:x:x:x and
x::x.
3. In the MLD Version field, the MLD protocol version used in periodic MLD queries is
displayed. The supported MLD Version is 1.
4. In the Query Interval field, specify the time interval in seconds between periodic queries
sent by the snooping querier. The Query Interval must be a value in the range of 1–1800
seconds. The default value is 60.