System information

142 | Chapter 4: Configuring Switching Information
GS752TXS Smart Switch Software Administration Manual
3. Use the Multicast Router field to enable or disable Multicast Router on the selected
interface.
4. Click Apply to apply the new settings to the switch. Configuration changes take effect
immediately
5. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
Multicast Router VLAN Configuration
The statically configured router attached (VLAN, Interface) is added to the learned multicast
router attached interface list if the interface is active and is a member of the VLAN. Unlike in
the previous release of the system firmware, Snooping dynamic learning mode (snooping
interface mode or snooping VLAN mode) does not need not be enabled on the interface. The
dynamic learning mode is applicable only for dynamically learnt multicast router information
(Queries from an attached true Querier).
To access the Multicast Router VLAN Configuration page, click Switching
 Multicast  MLD
Snooping
 Multicast Router Configuration VLAN Configuration.
To configure the Multicast Router VLAN:
1. Select the interface in unit/slot/port format in the Interface field and click on the Go
button. The entry corresponding to the specified interface will be selected.
2. Enter the VLAN ID in the VLAN ID field for which the Multicast Router Mode is to be
Enabled or Disabled.
3. Use the Multicast Router field to enable or disable Multicast Router on the selected
interface.