System information

Chapter 4: Configuring Switching Information | 139
GS752TXS Smart Switch Software Administration Manual
To configure the MLD interface:
1. Click 1, LAGs, or ALL
to configure the interface settings for a physical port,.
2. Enter the interface in unit/slot/port format in the Go To Interface field and click on the Go
button. The entry corresponding to the specified interface will be selected.
3. Select all physical, VLAN and LAG interface you want to configure.in the Interface field.
4. Select the interface mode for the selected interface for MLD Snooping for the switch from
the Admin Mode field. The default is disable.
5. Use the Group Membership Interval(secs) field to specify the amount of time you want the
switch to wait for a report for a particular group on a particular interface before it deletes that
interface from the group. The valid range is from (2 to 3600) seconds. The configured value
must be greater than Max Response Time. The default is 260 seconds.
6. Use the Max Response Time(secs) field to specify the amount of time you want the switch
to wait after sending a query on an interface because it did not receive a report for a
particular group on that interface. Enter a value greater or equal to 1 and less than the
Group Membership Interval in seconds. The default is 10 seconds. The configured value
must be less than the Group Membership Interval.
7. Use the Present Expiration Time(secs) field to specify the amount of time you want the
switch to wait to receive a query on an interface before removing it from the list of interfaces
with multicast routers attached. Enter a value between 0 and 3600 seconds. The default is 0
seconds. A value of zero indicates an infinite timeout, that is, no expiration.
8. Use the Fast Leave Admin Mode field to select the Fast Leave mode for a particular
interface from the menu. The default is Disable.
9. Click Apply to apply the new settings to the switch. Configuration changes take effect
immediately