System information

104 | Chapter 4: Configuring Switching Information
GS752TXS Smart Switch Software Administration Manual
4. Enter any number in the range of (1 to 4093) VLAN ID field. All the ports in the group will
assign this VLAN ID to untagged packets received for the protocols you included in this
group.
The Ports field displays all the member ports which belong to the group.
5. T
o add an entry of MAC Address to VLAN mapping, click Add.
6. To remove the Protocol Based VLAN group identified by the value in the Group ID field,
click Delete.
7. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
If you make any changes to this page, click Apply to send the updated configuration to the switch.
Configuration changes take place immediately.
Protocol Based VLAN Group Membership
To access the MAC Based VLAN page, click Switching VLAN  Advanced  Protocol
Based VLAN Group Membership.
To set up Protocol Based VLAN Group Membership:
1. Select the protocol-based VLAN Group ID for which you want to display or configure
data in the Group ID drop-down menu.
2. Port List - You can use this port list to add the ports you selected to this Protocol Based
VLAN Group. Note that a given interface can only belong to one group for a given protocol.
If you have already added a port to a group for IP, you cannot add it to another group that
also includes IP, although you could add it to a new group for IPX.
The Group Name field identifies the name for the protocol-based VLAN you selected. It
can be up to 32 alphanumeric characters long, including blanks.