Quick Start Manual

``
Green=Link at 1G
Yellow=Link at 10/
100M
Power
Reset
ID
Fan
Stack
Master
Facto ry
Defaults
1
2
3
4
5
6
7
8
9
10
11 13 15 17 19 21
12 2214 16 18 20
23 25 27 29 31 33
24 3426 28 30 32
35 37 39 41 43 45 47
36 38 40 42 44 46 48
GS752TXS
50F
49F
Green=10G Link Yellow=1G
Blink=ACT
SFP
+
52F
51F
Link/Act Mode —
24
GS728TXS/GS752TXS Smart Switch
Figure 8. Connecting devices to the switch
Note: Ethernet specifications limit the cable length between the switch and
the attached device to 100 meters (328 feet).
 To connect devices to the switch:
Using a Category 5 (Cat 5) unshielded twisted-pair (UTP) cable terminated with an RJ-45
con
nector, connect each computer to an RJ-45 network port on the switch front panel.
See the previous figure.
Step 5: Install an SFP Transceiver Module
The following procedure describes how to install an optional SFP (or SFP+) transceiver
module into one of the SFP ports of the switch.
Note: Contact your NETGEAR sales office to buy these modules. If you do
not want to install an SFP module, skip this procedure.
 To install an SFP transceiver:
1. Insert the tran
sceiver into the SFP port.
2. Press firmly on the flange
of the module to seat it securely into the connector.
You can install up to three additional Gigabit or 10-Giga
bit Ethernet modules using this
procedure. (The figure shows the GS752TXS Smart Switch; however, the GS728TXS
Smart Switch is connected in the same manner.)