User Manual

24-Port and 48-Port Gigabit Ethernet PoE+ Smart Switches with 4 SFP Ports
Maintain or Troubleshoot the switch User Manual499
5. Click the Go button.
The System Information page displays.
6. Select Maintenance > File Management > Copy.
7. Select the Source Image image1 or image2 radio button to specify the image to be copied.
8. Select the Destination Image image1 or image2 radio button to specify the destination
image.
9. Click the Apply button.
Your settings are saved.
Configure dual image settings
The Dual Image feature allows the switch to retain two images in permanent storage. You
can select which image must be loaded when the reboots, specify an image description, or
delete an image. This feature reduces switch down time when you are upgrading or
downgrading the software image.
Change the software image that loads when the switch starts or reboots
To change the image that loads during the boot process:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page 21 or Access the switch off-network and not
connected to the Internet on page 29.
The Device UI login page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see
Register the switch on page 32.
4. Enter one of the following passwords:
• Enter your device admin password.
• If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network location.