User Manual

24-Port and 48-Port Gigabit Ethernet PoE+ Smart Switches with 4 SFP Ports
Monitor the Switch and the Traffic User Manual478
7. Select an Admin Mode radio button:
• Disable. Port mirroring is enabled.
• Enable. Port mirroring is enabled.
8. From the Destination Port menu, select the destination port to which port traffic must be
copied.
Y
ou can configure only one destination port on the system. The port functions as a probe
port and receives traffic from all configured source ports. If no port is configured, None is
displayed.
The default is None.
9. Click the Apply button.
Your settings are saved.
The following steps must be performed in the Source Interface Configuration section.
10. Use one of the following methods to narrow down the ports that are displayed:
• Select Unit ID to display the physical ports of the selected unit.
• Select LAG to display a list of LAGs only.
• Select
CPU to display a list of CPUs only.
• Select All
to display a list of all physical ports, LAGs, CPUs, and VLANs.
11. Use one of the following methods to select one or more source ports:
• To select a single interface, select the check box associated with the port, or type the
port number in the
Go To Interface field and click the Go button.
• To select multiple interfaces with the same settings, select the check box associated
with each interface.
T
raffic from the selected ports is sent to the probe port.