User Manual

24-Port and 48-Port Gigabit Ethernet PoE+ Smart Switches with 4 SFP Ports
Get Started User Manual46
Use these links as follows:
• To display all ports, click the 1 link.
• To display all LAGs, click the LAGS link.
• To display all ports and LAGs, click the All
link.
The procedures in this section describe how to select the ports and LAGs to configure. The
procedures assume that you are already logged in to the switch. If you do not know how to
log in to the switch, see
Access the switch on-network and connected to the Internet on
page 21 or Access the switch off-network and not connected to the Internet on page 29.
To configure a single port by using the Go To Interface field:
1. Ensure that the page is displaying all ports, and not only the LAGs.
2. In the Go To Interface field, type the port number
.
For example, type g4.
For more information, see
Table 4, Naming conventions for interfaces on page 45.
3. Click the Go button.
The check box associated with the interface is selected, the row for the selected interface
is highlighted, and the interface number displays in the heading row.
4. Configure the desired settings.
5. Click the Apply button.
Your settings are saved.
To configure a single LAG by using the Go To Interface field:
1. Click the LAG link or the All link to display the LAGs.
2. In the Go T
o Interface field, type the LAG number
, for example l3.
For more information, see
Table 4, Naming conventions for interfaces on page 45.
3. Click the Go button.