User Manual

24-Port and 48-Port Gigabit Ethernet PoE+ Smart Switches with 4 SFP Ports
Get Started User Manual41
A pop-up window displays.
d. Navigate to a location on your computer and save the file.
The file transfer begins. The page displays information about the file transfer
progress.
12. Reset the switch to factory default settings:
a. Select Maintenance > Reset > Factory Default.
The Default Settings page displays.
b. Select the Reset configuration to factory default (EXCEPT registered device
status), and clear device logs radio button.
This option resets the switch to its factory default settings but does not change its
registration status with NETGEAR.
c. Click the Apply button.
An Alert pop-up window displays.
d. Click the OK button.
All configuration settings are reset to their factory default values. The DHCP client on
the switch is enabled.
Your device admin password is reset to the default password
(password). This process takes about 135 seconds.
The Device UI login page displays.
In the unlikely situation that the Device UI page does not display and you cannot log
in, see
Access the switch on-network and connected to the Internet on page 21 or
Access the switch off-network and not connected to the Internet on page 29.
e. Enter the device admin password.
The default device admin password is password.
The first time that you enter the
default device admin password, the Change Default Password page displays,
requiring you to customize the device admin password.
The System Information page displays.
Note: The following step uses an HTTP session to restore the configuration. For
information about using a TFTP session, see
Use TFTP to download a file
to the switch or update the software image on page 490.
13. Restore the configuration that you saved in
Step 11:
a. Select Maintenance > Update > HTTP Firmware/File Update.
The HTTP Firmware/File Update page displays.
b. From the File T
ype menu, select Text Configuration.
c. Click the Browse button and locate and select configuration file that yo
u saved in
Step 11.
d. Click the Apply button.