User Manual

24-Port and 48-Port Gigabit Ethernet PoE+ Smart Switches with 4 SFP Ports
Manage Device Security User Manual397
7. Select whether to display physical interfaces, LAGs, or both by clicking one of the following
links above the table heading:
•1 (the unit ID of the switch). Only physical interfaces are displayed.
This is the default
setting.
•
LAG. Only LAGs are displayed.
• All. Both physical interfaces and LAGs are displayed.
8. Select one or more interfaces by taking one of the following actions:
• T
o configure a single interface, select the check box associated with the port, or type
the port number in the
Go To Interface field and click the Go button.
• To configure multiple interfaces with the same settings, select the check box
associated with each interface.
• To configure all interfaces with the same settings, select the check box in the heading
row
.
9. From the Port VLAN Mode menu, select the switch port mode:
• General. Sets the interfaces in general mode, which is the default selection.
• Host. Sets the interfaces in host mode, which is used for private VLAN
configurations.
• Promiscuous. Sets the interfaces in promiscuous mode, which is used for private
VLAN configurations.
10. Click the Apply button.
Your settings are saved.
Configure a private VLAN host interface
To configure a private VLAN host interface:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.