User Manual

Table Of Contents

24-Port and 48-Port Gigabit Ethernet PoE+ Smart Switches with 4 SFP Ports

Manage Device Security User Manual360

The Certificate Present field displays whether a certificate is present on the switch.

7. In the Certificate Management section, select the Generate Certificates radio button.

8. Click the Apply button.

The switch generates an SSL certificate.

The Certificate Generation Status field shows information about the progress.

Delete an SSL certificate

Note: Before you can delete a certificate, you must disable HTTPS (see

Configure the HTTPS settings on page 357) and log back in to the

device UI over an HTTP session. After you delete the certificate, you

can reenable HTTPS and log back in to the device UI over an HTTPS

session.

To delete an SSL certificate:

1. Connect your computer to the same network as the switch.

You can use a WiFi or wired connection to connect your computer to the network, or

connect directly to a switch that is off-network using an Ethernet cable.

2. Launch a web browser.

3. In the address field of your web browser, enter the IP address of the switch.

If you do not know the IP address of the switch, see

Access the switch on-network and

connected to the Internet on page 21 or Access the switch off-network and not

connected to the Internet on page 29.

The Device UI login page displays.

If you did not yet activate your warranty, the Register to activate your warranty page

displays. For more information, see