User Manual

24-Port and 48-Port Gigabit Ethernet PoE+ Smart Switches with 4 SFP Ports
Manage Device Security User Manual343
8. In the Port field, specify the UDP port number the server uses to verify the RADIUS
accounting server authentication. The default UDP port number is 1813.
9. From the Secret Configured menu, select Ye
s to add a RADIUS secret in the next field.
You must select Ye
s before you can configure the RADIUS secret. After you add the
RADIUS accounting server, this field indicates whether the shared secret for this server
was configured.
10. In the Secret field, type the shared secret to use with the specified accounting server
.
11. From the Accounting Mode menu, select Enable to enable the RADIUS accounting mode.
12. Click the Add button.
The server is added to the switch.
13. Click the Apply button.
Your settings are saved.
Modify the settings for a RADIUS accounting server on the switch
To modify the settings for a RADIUS accounting server on the switch:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is of
f-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser
, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page 21 or Access the switch off-network and not
connected to the Internet on page 29.
The Device UI login page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see
Register the switch on page 32.
4. Enter one of the following passwords:
• Enter your device admin password.
• If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see
Credentials for the device UI on page 30.
5. Click the Go button.
The System Information page displays.
6. Select Security > Management Security > RADIUS >
Accounting Server Configuration.
The Accounting Server Configuration page displays.
7. Select the check box next to the server IP address.