User Manual

24-Port and 48-Port Gigabit Ethernet PoE+ Smart Switches with 4 SFP Ports
Configure Quality of Service User Manual325
must select a DSCP code from the menu. The DSCP value is defined as the
high-order six bits of the Service Type octet in the IP header.
14. Click the Apply button.
Your settings are saved.
The following table describes the nonconfigurable information displayed on the page.
Table 69. DiffServ policy configuration policy attribute
Field Description
Policy Name The name of the DiffServ policy.
Policy Type The type of the policy, which is always inbound (In).
Member Class Name The name of the class instance within the policy.
Rename an existing DiffServ policy
To rename an existing DiffServ policy:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page 21 or Access the switch off-network and not
connected to the Internet on page 29.
The Device UI login page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see
Register the switch on page 32.
4. Enter one of the following passwords:
• Enter your device admin password.
• If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see
Credentials for the device UI on page 30.
5. Click the Go button.
The System Information page displays.
6. Select QoS > DiffServ >
Advanced > Policy Configuration
.
The Policy Configuration page displays.
7. Select the check box next to the policy name.
8. In the Policy Name field, specify the new name.