User Manual

24-Port and 48-Port Gigabit Ethernet PoE+ Smart Switches with 4 SFP Ports
Configure Routing User Manual285
• Enter your device admin password.
• If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see
Credentials for the device UI on page 30.
5. Click the Go button.
The System Information page displays.
6. Select Routing> Router Discovery > Router Discovery Configuration.
7. Select a check box to the left of the Interface column to select the router interface.
8. From the Advertise Mode menu, select Enable or Disable.
If you select Enable, router advertisements are transmitted from the selected interface.
9. In the Advertise Address field, specify the IP address that must be advertised.
In the Maximum Advertise
Interval
field, enter the maximum time (in seconds) allowed
between router advertisements sent from the interface. The default value is 600.
10. In the Minimum Advertise Interval field, enter the minimum time (in seconds) allowed
between router advertisements sent from the interface.
The value must be in the range of 3 to 1800. The default value is 450.
In the Advertise Lifetime field, enter the value (in seconds) to be used as the lifetime
field in router advertisements sent from the interface.
This is the maximum length of time that the advertised addresses are to be considered as
valid router addresses by hosts. The default value is 1800.
1
1. In the Preference Level field, specify the preference level of the router as a default router
relative to other routers on the same subnet.
Higher numbered addresses are preferred. You must enter an integer. The default value
is 0.
12. Click the Apply button.
Your settings are saved.