User Manual

24-Port and 48-Port Gigabit Ethernet PoE+ Smart Switches with 4 SFP Ports
Configure Routing User Manual269
6. Select Routing> IPv6 > Advanced > Prefix Configuration.
7. From the Interface menu, select the interface to be configured.
When the selection is changed, the page refreshes, causing all fields to be updated for
the newly selected interface.
8. In the IPv6 Prefix field, specify the IPv6 prefix for an interface.
9. In the Prefix Length field, specify the IPv6 prefix length for an interface.
10. From the EUI64 menu, select Enable or Disable to indicate whether the specified 64-bit
unicast prefix is enabled.
11. In the V
alid Life Time field, specify the router advertisement per prefix time.
This is the time allowed to consider the prefix valid for the purpose of on-link
determination. The valid life time is 0 to 4294967295.
12. In the
Preferred Life Time field, specify the router advertisement per prefix time.
An autoconfigured address generated from this prefix is preferred. The preferred life time
must be in the range 0 to 4294967295.
13. From the Onlink Flag menu, select Enable or Disable to specify whether the selected
prefix can be used for on-link determination.
The default is Enable.
14. From the Autonomous Flag menu, select Enable or Disable to specify whether the
selected prefix can be used for autonomous address configuration.
The default value is Enable.
The Current State field displays the state of the IPV6 address. The state is TENT if
routing is disabled or DAD fails.
The state is Active if the interface is active and DAD is
successful.
15. Click the Add button.
The IPv6 address is added to the interface.
16. Click the Apply button.
Your settings are saved.