User Manual

24-Port and 48-Port Gigabit Ethernet PoE+ Smart Switches with 4 SFP Ports
Configure Routing User Manual259
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see
Register the switch on page 32.
4. Enter one of the following passwords:
• Enter your device admin password.
• If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see
Credentials for the device UI on page 30.
5. Click the Go button.
The System Information page displays.
6. Select Routing > IP > IP Configuration.
7. Select the Routing Mode Enable radio button.
You must enable routing for the switch before you can route through any of the
interfaces. Routing is also enabled or disabled per VLAN interface. The default value is
Disable.
8. Click the Apply
button.
Your settings are saved.
The following table describes the IP configuration information displayed on the page.
Table 55. Global IP status information
Field Description
Default Time to Live The default value inserted into the Time-To-Live field of the IP header of
datagrams originated by the switch, if a TTL value is not supplied by the
transport layer protocol.
The default value is 64.
Maximum Next Hops The maximum number of hops supported by the switch. This is a compile-time
constant.
The default value is 1.
View the IP routing statistics
You can view the IP routing statistics as specified in RFC 1213.
To view the IP routing statistics:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.