User Manual

24-Port and 48-Port Gigabit Ethernet PoE+ Smart Switches with 4 SFP Ports
Configure Switching User Manual256
• Both. The switch both logs a message and disables the interface.
11. Click the Apply button.
Your settings are saved.
12. Click the Clear button to clear all the statistics in the table.
13. Click the Refresh button to refresh the page with the latest information about the switch.
The following table describes the nonconfigurable information displayed on the page.
Table 54. L2 Loop Protection Interface Information
Field Description
Loop Detected Shows whether a loop is detected on the interface. If the interface is
disabled and then reenabled, the status changes to No again.
Loop Count The number of packets that were received after the loop was detected.
Time Since Last Loop The time that elapsed since the loop was detected.
Port Status The status of the interface (Enabled, Disabled, or D-Disabled, which stands
for diagnostically disabled).