User Manual

24-Port and 48-Port Gigabit Ethernet PoE+ Smart Switches with 4 SFP Ports
Configure Switching User Manual250
7. Use the Search menu and field to search for a MAC address, VLAN ID, or interface number:
• Search by MAC Address. From the Search menu, select MAC Address, and enter
the 6-byte hexadecimal MAC address in two-digit groups separated by colons, for
example, 01:23:45:67:89:AB. Then click the
Go button.
If the address exists, that entry is displayed as the first entry followed by the
remaining (higher) MAC addresses. An exact match is required.
•
Search VLAN ID. From the Search menu, select VLAN ID, and enter the VLAN ID, for
example, 100. Then click the Go button.
• Search Interface. From the Search menu, select Interface, and enter the interface ID
using the respective interface naming convention (for example, g1 or l1). Then click the
Go
button.
The following table describes the nonconfigurable information displayed on the page.
Table 53. MAC Address Table information
Field Description
Total MAC Address The number of total MAC addresses learned or configured.
MAC Address The unicast MAC address for which the switch holds forwarding and/or filtering
information. The format is a 6-byte MAC address that is separated by colons, for
example 01:23:45:67:89:AB.
VLAN ID The VLAN ID associated with the MAC address.
Interface The interface upon which this address was learned.
Status The status of this entry
. The meanings of the values are as follows:
Set the dynamic address aging interval
You can set the address aging interval for the forwarding database. This is the time-out
period in seconds for aging out dynamically learned forwarding information.
To set the dynamic address aging interval:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
• Static. The value of the corresponding instance was added by the system or a user
and cannot be relearned.
• Learned. The value of the corresponding instance was learned, and is being used.
• Management. The value of the corresponding instance is also the value of an
existing instance of dot1dStaticAddress.