User Manual

24-Port and 48-Port Gigabit Ethernet PoE+ Smart Switches with 4 SFP Ports
Configure Switching User Manual244
For information about the credentials, see Credentials for the device UI on page 30.
5. Click the Go button.
The System Information page displays.
6. Select Switching > MVR >
Advanced > MVR Group Configuration.
7. In the MVR Group IP field, specify the IP address for the new MVR group.
8. In the Count field, specify the number of contiguous MVR groups.
This number helps you to create multiple MVR groups through a single click of the Add
button. If the field is empty
, then clicking the button creates only one new group.
The field
is displayed as empty for each particular group. The range is from 1 to 256.
9. Click the Add button.
The MVR group is added.
The following table describes the nonconfigurable information displayed on the page.
Table 51. MVR Group Configuration
Field Definition
Status The status of the specific MVR group.
Members The list of ports that participate in the specific MVR group.
Configure MVR group membership
To configure MVR group membership:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page 21 or Access the switch off-network and not
connected to the Internet on page 29.
The Device UI login page displays.