User Manual

24-Port and 48-Port Gigabit Ethernet PoE+ Smart Switches with 4 SFP Ports
Configure Switching User Manual243
9. In the MVR Global Query Response Time field, set the maximum time that the switch must
wait for an IGMP group membership report before removing the port from the multicast
group membership.
This time applies only to receiver-port leave processing. When an IGMP query is sent
from a receiver port, the switch waits for the default or configured MVR query time for an
IGMP group membership report before removing the port from the multicast group
membership.
The value is equal to tenths of a second.
The range is from 1 to 100 tenths.
The default is 5 tenths or one-half.
10. From the MVR Mode menu, specify the MVR mode of operation.
The options are compatible and dynamic.
The default is compatible.
1
1. Click the Apply button.
Your settings are saved.
12. T
o refresh the page with the latest information about the switch, click the Refresh
button.
The following table describes the nonconfigurable information displayed on the page.
Table 50. MVR Configuration information
Field Definition
MVR Max Multicast Groups The maximum number of multicast groups that MVR supports.
MVR Current Multicast Groups The number of MVR groups allocated.
Configure an MVR group
To configure an MVR group:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page 21 or Access the switch off-network and not
connected to the Internet on page 29.
The Device UI login page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see
Register the switch on page 32.
4. Enter one of the following passwords:
• Enter your device admin password.
• If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network location.