User Manual

24-Port and 48-Port Gigabit Ethernet PoE+ Smart Switches with 4 SFP Ports
Configure Switching User Manual226
If you do not know the IP address of the switch, see Access the switch on-network and
connected to the Internet on page 21 or Access the switch off-network and not
connected to the Internet on page 29.
The Device UI login page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see
Register the switch on page 32.
4. Enter one of the following passwords:
• Enter your device admin password.
• If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see
Credentials for the device UI on page 30.
5. Click the Go button.
The System Information page displays.
6. Select Switching> Multicast > IGMP Snooping Querier > Querier Configuration.
7. Configure the following settings:
• Querier Admin Mode. Enable or disable IGMP snooping for the switch. The default is
Disable.
•
Snooping Querier IP Address. Enter the snooping querier IP address to be used as
the source address in periodic IGMP queries. This address is used when no address
is configured on the VLAN on which a query is being sent.
•
IGMP Version. Specify the IGMP protocol version used in periodic IGMP queries.
The range is 1 to 2. The default value is 2.
•
Query Interval(secs). Specify the time interval in seconds between periodic queries
sent by the snooping querier.
The query interval must be a value in the range of 1 and
1800. The default value is 60.
• Querier Expiry Interval(secs). Specify the time interval in seconds after which the
last querier information is removed. The querier expiry Interval must be a value in the
range of 60 and 300.
The default value is 125.
8. Click the Apply button.
Your settings are saved.