User Manual

Table Of Contents

24-Port and 48-Port Gigabit Ethernet PoE+ Smart Switches with 4 SFP Ports

Configure System Information User Manual110

The following table describes the SNMP Supported MIBs Status fields.

Table 24. SNMP supported MIBs

Field Description

Name The RFC number if applicable and the name of the MIB.

Description The RFC title or MIB description.

Configure SNMPv3 users

Any user can connect to the switch using the SNMPv3 protocol, but for authentication and

encryption, the switch supports only one user (admin). Therefore, you can create or modify

only one profile.

To configure authentication and encryption settings for the SNMPv3 admin profile by

using the web interface:

1. Connect your computer to the same network as the switch.

You can use a WiFi or wired connection to connect your computer to the network, or

connect directly to a switch that is off-network using an Ethernet cable.

2. Launch a web browser.

3. In the address field of your web browser, enter the IP address of the switch.

If you do not know the IP address of the switch, see

Access the switch on-network and

connected to the Internet on page 21 or Access the switch off-network and not

connected to the Internet on page 29.

The Device UI login page displays.

If you did not yet activate your warranty, the Register to activate your warranty page

displays. For more information, see

4. Enter one of the following passwords:

• Enter your device admin password.