Owner's Manual
Table Of Contents
- Smart Switch Software User Manual GS748T
- Contents
- About This Manual
- Chapter 1 Switch Management Overview
- Chapter 2 Using the Smartwizard Discovery Utility
- Chapter 3 Basic Web Management
- Chapter 4 Configuring the Switch
- Configuring Ports
- Configuring the Link Aggregation Group (LAG)
- Setting Up SNMP
- Configuring and Creating VLANs
- Enabling Spanning Tree Protocol
- Establishing Multicast Groups
- Enabling Jumbo Frames
- Setting Rate Limits
- Setting QoS Global Configuration
- Enabling Storm Control
- Configuring the IP Access List
- Controlling Switch Access by MAC Address and VLAN ID
- Setting up Mirroring or “Sniffer Ports”
- Viewing Packet Statistics
- Appendix A Specifications and Default Values
- Appendix B Virtual Local Area Networks (VLANs)
- Appendix C Network Cabling
Smart Switch Software User Manual GS748T
Specifications and Default Values A-3
v1.0, October 2007
Trust Matadors Filter 256 Disabled
Port -MAC lock down 48 (per port) Disabled
Management VLAN 1 0
Table A-6. Traffic Control
Feature Sets Supported Default
Rate control 48 (per port) Disabled
Storm control 1 (per switch) Disabled
Jumbo frame 48 (per port) Disabled
Table A-7. System Setup
Feature Sets Supported Default
DHCP\Manual IP 1 192.168.0.239
System Name Configuration 1 NULL
Configuration Save/Restore 1 N/A
Firmware Upgrade 1 N/A
Factory Reset 1 N/A
Table A-8. Other Features
Feature Sets Supported Default
Static Multicast Entry 64 Disabled
Filter Multicast Control 1 Disabled
Table A-9. Management
Feature Sets Supported Default
SNMPv1/V2c 4 Disabled
MIB Support 1 Disabled
Table A-5. Security (continued)
Feature Sets Supported Default