Owner's Manual
Table Of Contents
- Smart Switch Software User Manual GS748T
- Contents
- About This Manual
- Chapter 1 Switch Management Overview
- Chapter 2 Using the Smartwizard Discovery Utility
- Chapter 3 Basic Web Management
- Chapter 4 Configuring the Switch
- Configuring Ports
- Configuring the Link Aggregation Group (LAG)
- Setting Up SNMP
- Configuring and Creating VLANs
- Enabling Spanning Tree Protocol
- Establishing Multicast Groups
- Enabling Jumbo Frames
- Setting Rate Limits
- Setting QoS Global Configuration
- Enabling Storm Control
- Configuring the IP Access List
- Controlling Switch Access by MAC Address and VLAN ID
- Setting up Mirroring or “Sniffer Ports”
- Viewing Packet Statistics
- Appendix A Specifications and Default Values
- Appendix B Virtual Local Area Networks (VLANs)
- Appendix C Network Cabling
Smart Switch Software User Manual GS748T
4-24 Configuring the Switch
v1.0, October 2007
Viewing Packet Statistics
The Port Statistics screen shows reports of packet traffic and packet errors formatted as follows:
• Port Selection: The port number on the switch—selected from the Port pull-down menu.
• Statistics: Detailed Tx and Rx statistical information, by port.
• Summary Statistics: All ports Tx and Rx statistics summarized. Presents the information
from each port’s internal counters.
To view statistics for a single port:
1. From the Port pull-down menu, select the port number.
2. Click Apply.
To retrieve summary statistics.
1. Click Refresh to retrieve the current count from the device and update the tables.
2. Click Clear Counters to reset all counters to zero.
Figure 4-23