Owner's Manual

GS700TPS Smart Switch Software Administration Manual
Maintenance 8-8
v1.0, June 2009
To test cables:
1. Click Maintenance > Troubleshooting > Cable Test. The Cable Test screen displays:
The Cable Test screen contains the following fields:
• Interface – Enter the port to which the cable is connected.
• Test Result – Displays the cable test results. Possible values are:
– No Cable – Indicates a cable is not connected to the port.
– Open Cable – Indicates a cable is connected on only one side.
– Short Cable – Indicates a short has occurred in the cable.
– OK – Indicates the cable passed the test.
• Cable Fault Distance – Displays the distance from the port where the cable error
occurred.
• Last Update – Displays the last time the port was tested.
• Test – Click TEST to perform the cable tests for the selected port.
Figure 8-6