Manualshelf

User Guide

ManualsBrandsNETGEAR ManualsComputers & AccessoriesNETGEAR GS748T-500NAS 48-Port Gigabit Ethernet Smart Managed Pro Switch, 4 SFP, ProSAFE Lifetime Protection (GS748T)
141142143144145146147148149150
Configuring Routing
148
GS716Tv3, GS724Tv4, and GS748Tv5 Smart Switches
Configure IP Settings
For information about how to configure and display IP routing data, see the following
sections:
• IP Configuration
• VLAN Routing Wizard
• IP Statistics
IP Configuration
Use the IP Configuration screen to configure routing parameters for the switch.
To enable routing on the switch:
1. Select Routing > IP > IP Configuration.
2. Next to Routing Mode, select Enable.
You must enable routing for the switch before you can route through any of the interfaces.
Routing is also enabled or disabled per VLAN interface. The default value is Disable.
3. Click the Apply button.
The following table describes the IP configuration information displayed on the screen.
Table 50. Global IP status information
Field Description
Default Time to Live The default value inserted into the Time-To-Live field of the IP
header of datagrams originated by the switch, if a TTL value is not
supplied by the transport layer protocol. The default value is 64.
Maximum Next Hops The maximum number of hops supported by the switch. This is a
compile-time constant. The default value is 1.