Other Content

The following models support complete standard MIBs: FS728Tv2 FS752TP GS108Tv2
GS110TP GS716Tv2 GS724Tv3 GS748Tv4 GS724/48TP GS7xxTS/TPS...
 How can I troubleshoot LAN connectivity problems on my NETGEAR ProSAFE or Nighthawk Switch?
LAN connectivity problems on a switch can be caused by any of a wide range of factors. Below
are some simple things to check which can help to resolve common problems. Power cycle the
switch and other network equipment. En...
 The VLAN and LAG configuration screens do not display correctly on my switch
On some NETGEAR switches (see the list at the bottom of this article), VLAN Membership and
LAG Membership screens do not display the section where ports are added to a VLAN or LAG
with the following browsers:...
 How do I access the admin page of my NETGEAR ProSAFE switch?
Fully Managed Switches, Smart Managed Switches, Web Managed (Plus) Switches & Web
Managed Click Switches all have an admin page that you use to configure settings on the switch.
Unmanaged switches do not have an admin page. If you...
roubleshooting
Articles
 Is my NETGEAR product affected by the 'shellshock' bug (CVE-2014-6271 / CVE-2014-7169)?
NETGEAR Access Point, Wireless Controllers, Smart Switches, Managed Switches and
majority of ProSAFE Firewall do not use BASH shell that is vulnerable to this "shellshock" bug.
NETGEAR cloud services are not exposed to this bug. <...
 Why is there latency or no reply when pinging the IP address of my switch?
This article does not apply to unmanaged switches. The management interface of your switch
relies on the CPU of the switch to respond to ICMP ping requests. Such requests are given a low
priority by the switch CPU relative...
 Adding a MAC ACL on Fully and Smart Managed switches to prevent STP leak of multicast packet from 3rd
party access points