Quick Start Manual

GS752TP, GS728TP, and GS728TPP Gigabit Smart Switch

3. Tighten the screws with a No. 1 Phillips screwdriver to secure each bracket.

4. Align the mounting holes in the brackets with the holes in the rack, and insert two pan-head

screws with nylon washers through each bracket and into the rack.

5. T

ighten the screws with a No. 2 Phillips screwdriver to secure mounting brackets to the rack.

Figure 10. Rack mount

Step 3: Check the Installation

Before applying power to the switch, perform the following steps:

• Inspect the equipment thoroughly

• V

erify that all cables are installed correctly.

• Check cable routing to make sure that cables are not damaged or creating a safety

hazard.

• Ensure that all equipment is mounted properly and securely