User Manual

24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Configure System Information User Manual95
Configure SNMP
You can configure SNMP settings for SNMPv1/v2 and SNMPv3. The switch supports the
configuration of SNMP groups and users that can manage traps that the SNMP agent
generates.
The switch uses both standard public MIBs for standard functionality and private MIBs that
support additional switch functionality.
The main object for interface configuration is in the
NetgearSmartSwitch-MIB, which is a private MIB. Some interface configurations also involve
objects in the public MIB, IF-MIB.
Configure the SNMPv1 and SNMPv2 community
Only the communities that you define can access to the switch using the SNMP V1 and
SNMP V2 protocols. Only those communities with read/write level access can be used to
change the configuration using SNMP.
Status The operational status of the port. The possible values are as follows:
• Disabled. No
power is delivered.
• DeliveringPower. Power is being drawn by the PD.
• Fault. A problem occurred with the power.
• Test. The port is in test mode.
• otherFault. The port is idle because of an error condition.
• Searching. The port is not in one of the other states in this list.
Fault Status The error description when the PoE port is in a fault state. The possible values are
as follows:
• No Error. The port is not in any error state and can provide power.
• MPS Absent. The port detected the absence of the main power supply,
preventing the port from providing power.
• Short. The port detected a short circuit condition, preventing the port from
providing power.
• Overload. The PD that is connected to the port attempts to draw more power
than allowed by the port’s settings, preventing the port from providing power at
all.
• Power Denied. The port was denied power because of a shortage of power or
because of an administrative condition. In this condition, the port cannot
provide power.
Table 17. PoE Port Configuration (continued)
Field Description