User Manual

24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Configure System Information User Manual87
not dropped or corrupted in transition to and from low power mode. Transition time is
transparent to upper layer protocols and applications.
10. Click the Apply button.
Your settings are saved.
Manage switch discovery with UPnP and
SSDP
By default, Universal Plug and Play (UPnP) and Simple Service Discovery Protocol (SSDP)
are enabled on the switch. UPnP and SSDP allow the switch to be discovered in your
network, for example on Windows-based computers and mobile devices on the NETGEAR
Insight app is installed. For greater security you can disable UPnP and SSDP.
You cannot manage the settings for these protocols independently.
To manage switch discovery with UPnP and SSDP:
1. Connect your
computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ether
net cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page 19 or Access the switch off-network and not
connected to the Internet on page 27.
The Device UI login page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see
Register the switch on page 30.
4. Enter one of the following passwords:
• After registration, enter the device admin password.
• If you previously managed the switch through the Insight app or
Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see
Credentials for the device UI on page 28.
5. Click the Go
button.
The System Information page displays.
6. Select System >
Management > Switch Discovery > UPnP / SSDP
The UPnP / SSDP page displays.