User Manual

24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Maintain or Troubleshoot the Switch User Manual397
7. In the IPv6 Address/Hostname field, enter the IPv6 address or host name of the station
that must be pinged.
The format is xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx. The maximum number of
characters is 255.
8. In the Count
field, enter the number of echo requests that must be sent.
The range is 1 to 15. The default value is 3.
9. In the Interval (secs)
field, enter the time in seconds between ping packets.
The range is 1 to 60. The default value is 3.
10. In the Size
field, enter the datagram size.
The valid range is 0 to 13000. The default value is 0 bytes.
11. Click the Apply
button.
The specified address is pinged. The results are displayed below the configurable
data in
the Results field.
Send an IPv4 traceroute
You can configure the switch to send a traceroute request to a specified IPv4 address or host
name. You can use this to discover the paths that packets take to a remote destination.
When you send a traceroute, the switch displays the results below the configurable data.
If a reply to the traceroute is received, the following message displays:
traceroute to x.y.z.w (x.y.z.w), maxTTL hops max, size byte packets
initTTL x.y.z.w (x.y.z.w) 0.000 ms * 0.000 ms
initTTL+1 x.y.z.w (x.y.z.w) 0.000 ms * 0.000 ms
initTTL+2 x.y.z.w (x.y.z.w) 0.000 ms * 0.000 ms