User Manual

24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Maintain or Troubleshoot the Switch User Manual392
9. Click the Apply button.
Your settings are saved.
10. After activating the image, reboot the switch (see
Reboot the switch on page 376).
If you do not reboot the switch, it continues running the image shown
in the Current-active
field until the next time that the switch reboots.
Delete a software image
To delete a software image:
1. Connect your
computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ether
net cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page 19 or Access the switch off-network and not
connected to the Internet on page 27.
The Device UI login page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see
Register the switch on page 30.
4. Enter one of the following passwords:
• Enter your device admin password.
• If you previously managed the switch through the Insight app or
Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see
Credentials for the device UI on page 28.
5. Click the Go
button.
The System Information page displays.
6. Select Maintenance >
File Management > Dual Image Configuration.
The Dual Image Configuration page displays.
7. From the Image
Name menu, select the image that is not the image displayed in the
Current-active field.
The Current-active field displays the name of the active image. Y
ou cannot delete the
active image.
8. Select the Delete Image check box.
9. Click the Apply
button.
The image is removed.