User Manual

24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Maintain or Troubleshoot the Switch User Manual390
Note: A switch that runs an older (legacy) software version might not load a
configuration file that is created by a newer software version. In such
a situation, the switch displays a warning.
Copy a software image
You can copy a software image from one location (primary or backup) to another.
To copy a software image:
1. Connect your computer
to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch
a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page 19 or Access the switch off-network and not
connected to the Internet on page 27.
The Device UI login page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see
Register the switch on page 30.
4. Enter one of the following passwords:
• Enter your device admin password.
• If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network locat
ion.
For information about the credentials, see
Credentials for the device UI on page 28.
5. Click the Go
button.
The System Information page displays.
6. Select Maintenance > File
Management > Copy.
7. Select the Source Image image1 or image2 radio button to specify the image to be copied.
8. Select the Destination Image image1 or image2
radio button to specify the destination
image.
9. Click the Apply
button.
Your settings are saved.