User Manual

24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Maintain or Troubleshoot the Switch User Manual385
Note: We recommended that you do not overwrite the active image.
9. From the Server
Address Type menu, select the format for the TFTP Server IP field:
• IPv4. Indicates that the TFTP server address is an IP address in dotted-decimal
format.
This is the default setting.
• DNS. Indicates that the TFTP server address is a host name.
10. In the TFTP
Server IP field, enter the IP address of the TFTP server indicated by the server
address type.
The default is the IPv4 address 0.0.0.0.
11. In the T
ransfer File Path field, specify the path on the TFTP server where the file is located.
Enter up to 160 characters. Include the backslash at the end of the path. A path name
with a space is not accepted. Leave this field blank to save th
e file to the root TFTP
directory.
12. In the Remote
File Name field, specify the name of the file to download from the TFTP
server.
You can enter up to 32 characters. A file name with a space is not accepted.
13. Select the Start
File Transfer check box to initiate the file upload.
14. Click the Apply
button.
The file transfer begins.
The page displays information about the progress of the file transfer.
The page refreshes
automatically when the file transfer completes.
Note: After you download a text configuration file, the switch applies the
configuration automatically.
15. After
you download a software image file, if you want the switch to run the software image,
do
the following:
a. Select the new software image file (see
Change the software image that loads when
the switch starts or reboots on page 391).
b. Reboot the
switch (see Reboot the switch on page 376).