User Manual

24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Manage Device Security User Manual310
• IPv4
• IPv6
• IPX
• MPLS Multicast
• MPLS Unicast
• NetBios
• Novell
• PPPOE
• RARP
• User Value
18. If
you select User
Value from the EtherType Key menu, in the EtherType User Value field,
specify the customized EtherType value that must be used.
This value must be compared against the information in an Ethernet frame. The range is
from 0x0600 to 0xFFFF.
19. In the Source
MAC field, specify the source MAC address that must be compared against
the information in an Ethernet frame.
The format is xx:xx:xx:xx:xx:xx.
20. In the Source
MAC Mask field, specify the source MAC address mask that must be
compared against the information in an Ethernet frame.
The format is xx:xx:xx:xx:xx:xx.
21. In the VLAN
field, specify the VLAN ID that must be compared against the information in an
Ethernet frame.
The range is from 1 to 4093. You can configure either a single VLAN or a VLAN range.
22. From the Logging
menu, select whether to enable or disable logging.
If you select Enable, logging is enabled for this ACL rule (subject to resource ava
ilability
on the switch).
23. Click the Add button.
The rule is added.
Change the match criteria for a MAC rule
To change the match criteria for a MAC rule:
1. Connect your
computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ether
net cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.