User Manual

24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Manage Device Security User Manual260
If you do not know the IP address of the switch, see Access the switch on-network and
connected to the Internet on page 19 or Access the switch off-network and not
connected to the Internet on page 27.
The Device UI login page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see
Register the switch on page 30.
4. Enter one of the following passwords:
• Enter your device admin password.
• If you previously managed the switch through the Insight app or
Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see
Credentials for the device UI on page 28.
5. Click the Go
button.
The System Information page displays.
6. Select Security >
Management Security > SCC Control.
The NETGEAR Smart Control Center (SCC) Utility page displays.
7. Select the one of the following SCC Admin Mode radio buttons:
•
Enable. The SCC can discover the switch and perform actions on the sw
itch.
• Disable. The SCC can discover the switch but cannot perform any action
s on the
switch. This is the default setting.
8. Click the Apply
button.
Your settings are saved.
Configure management access
You can configure the global settings for HTTP and secure HTTP (HTTPS) access to the
switch’s device UI. You can also configure access control profiles and access rules.
Configure HTTP access settings
You can configure the HTTP access settings on the switch. If you access the switch
device UI, HTTP is the default access method.
To configure the HTTP access settings:
1. Connect your
computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ether
net cable.