User Manual

24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Manage Device Security User Manual248
5. Click the Go button.
The System Information page displays.
6. Select Security > Management
Security > RADIUS > Accounting Server Configuration.
The previous figure does not show the Accounting Server Statistics section.
7. In the Accounting Server
Address field, specify the IP address of the RADIUS accounting
server to add.
8. In the Port
field, specify the UDP port number that the server uses to verify the RADIUS
accounting server authentication.
The default UDP port number is 1813.
9. From the Secret Configured
menu, select Yes to add a RADIUS secret in the next field.
You must select Yes before you can configure the RADIUS secret. After you add the
RADIUS accounting server
, this field indicates whether the shared secret for this server
was configured.
10. In the Secret
field, type the shared secret to use with the specified accounting server.
11. From the Accounting Mode
menu, select Enable to enable the RADIUS accounting mode.
12. Click the Apply
button.
Your settings are saved.
13. To reset the accounting server and RADIUS statistics to their default values, click the Clear
Counters
button.
14. The following table describes the nonconfigurable information in the Accounting
Server
Statistics table on the page.
Table 48. RADIUS accounting server statistics information
Field Description
Accounting Server Address The accounting server associated with the statistics.
Round Trip Time (secs) The time interval, in hundredths of a second, between the most recent
accounting-response and the accounting-request that matched it from this
RADIUS accounting server.
Accounting Requests The number of RADIUS accounting-request packets sent not including
retransmissions.