User Manual

24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Configure Quality of Service User Manual230
• Mark IP Precedence. Select this radio button to require packets to be marked with an
IP precedence value before being forwarded. You must select an IP precedence
value from 0 to 7 from the menu.
• Mirror. Select this radio button to require packets to be mirrored to an interface or
LAG, one of which you must select from the menu.
• Redirect. Select
this radio button to require packets to be redirected to an interface or
LAG, one of which you must select from the menu.
• Mark IP DSCP. Select this radio button to require packet to be marked with an IP
DSCP keyword code, which you must select from the menu. The DSC
P value is
defined as the high-order 6 bits of the Service Type octet in the IP header.
• Simple Policy. Select this radio button to define the traffic policing style
for the class.
By default, this simple policy is color blind, and color classes do not apply. A simple
policy supports a single data rate and results in one of two outcomes: conform or
violate. Packets that violate the policy are always dropped. That is, you cannot specify
any other action for those packets. You must specify a policy action for packets that
conform to the policy.
- Committed Rate. Enter the committed rate that is applied to conforming packets
by specifying a value in the range from 16 to 1000000 Kbps.
- In the Conform
Action section, select
one of the following radio buttons:
• Send. Packets are forwarded unmodified. This is the default confirming action.
•
Drop. Packets are dropped. This is the default (and only) violating
action.
• Mark CoS. Packets are marked by DiffServ with the specified CoS value
before
being forwarded. This selection requires that the Mark CoS field is set.
You must select a CoS value from 0 to 7 from the menu.
• Mark IP Precedence. These
packets are marked by DiffServ with the specified
IP Precedence value before being forwarded. This selection requires that the
Mark IP Precedence field is set. You must select an IP precedence value from
0 to 7 from the menu.
• Mark IP DSCP.
Packets
are marked by DiffServ with the specified DSCP value
before being forwarded. This selection requires that the DSCP field is set. You
must either select a DSCP code from the menu or enter an IP DSCP value
from 0 to 63 in the field next to the menu. A value that you enter in the field
overrides any selection from the menu.
The DSCP value is defined as the high-order six bits of the Service
T
ype octet
in the IP header.
12. Click the Apply
button.
Your settings are saved.
Rename an existing DiffServ policy
To rename an existing DiffServ policy:
1. Connect your
computer to the same network as the switch.