User Manual

24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Get Started User Manual19
Access the switch on-network and
connected to the Internet
The DHCP client on the switch is enabled by default, allowing a DHCP server or router on the
network to assign an IP address to the switch.
If the switch is on-network, connected to a DHCP server, and connected to the Internet, you
can use a Windows-based computer to access the device UI of the switch and register the
switch with NETGEAR. For more information, see
Use a Windows-based computer to
access the switch on-network and connected to the Internet on page 20.
If you use a Mac, or if you do not know
the IP address of the switch, use one of the following
tools to discover the IP address of the switch on the network:
• NETGEAR Insight app. Y
ou can install the NETGEAR Insight app on an iOS or Android
mobile device and discover the IP address of the switch. See
Use the NETGEAR Insight
mobile app to discover the IP address of the switch on page 21.
• NETGEAR Switch Discovery Tool (NSDT): If you use a Mac or a Windows-based
computer, you can use the NSDT to discover the switch on your n
etwork. See
Use the
NETGEAR Switch Discovery Tool to discover the switch when it is connected to the
Internet on page 22.
• NETGEAR Smart Control Center (SCC): You can install the SCC on a Windows-based
computer. See
Discover the switch in a network with a DHCP server using the Smart
Control Center on page 24
• Other tools. You can also get the IP address of the switch from the DHCP server in the
network or use an IP scanner utility. See
Use other options to discover the switch IP
address on page 25.
When you know the IP address, you can configure the switch in the following ways:
• Device UI. For configuration of all switch features, access the switch over the device UI.
See
Access the switch on-network and connected to the Internet when you know the
switch IP address on page 25.
• NETGEAR Smart Control Center (SCC): For
configuration of a limited number of switch
features, use the SCC on a Windows-based computer. By default, you can use the SCC
to discover the IP address of the switch, but you cannot use the SCC to perform any
actions on the switch. However, if you enable the configuration option of the SCC, you
can use it to configure the switch. See
Manage the Smart Control Center on page 259.
For more information about the SCC, visit
netgear.com/support/product/SCC.
• NETGEAR Insight app and Insight Cloud portal. Y
ou can change the management
mode of the switch so that you can use the NETGEAR Insight app and Insight Cloud
portal to manage the switch remotely. For more information, see
Change the
management mode of the switch on page 35.