User Manual

24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Configure Switching User Manual138
• Enter your device admin password.
• If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see
Credentials for the device UI on page 28.
5. Click the Go
button.
The System Information page displays.
6. Select Switching > LAG
> Basic > LAG Membership.
7. From the LAG ID menu, select the LAG ID.
8. In the LAG Name field,
enter the name to be assigned to the LAG.
You can enter any string of up to 15 alphanumeric characters. A valid name must be
specified for you to create the LAG.
9. In the Ports table, click each
port that you want to include as a member of the selected
LAG.
A selected port is displayed by a check mark.
10. Click the Apply
button.
Your settings are saved.
Set the LACP system priority
You can set the LACP system priority that applies to all LAGs on the switch.
To set the LACP system priority:
1. Connect your computer
to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch
a web browser.
3. In the address field of your web browser, enter the IP address of the switch.