User Manual

Manage Device Security
229
NETGEAR 24-Port Gigabit Smart Managed Pro Switch with PoE+ and 2 SFP Ports Model GS724TPv2
14. In the Destination MAC Mask field, specify the destination MAC address mask that must
be compared against the information in an Ethernet frame.
The valid format is xx:xx:xx:xx:xx:xx. The BPDU keyword can be specified using a
destination MAC mask of 00:00:00:ff:ff:ff.
15. From the EtherType Key menu, select the EtherType value that must be compared against
the information in an Ethernet frame.
The valid values are as follows:
• Appletalk
• ARP
• IBM SNA
• IPv4
• IPv6
• IPX
• MPLS multicast
• MPLS unicast
• NetBIOS
• Novell
• PPPoE
• Reverse ARP
• User Value
16. In the EtherType User Value field, specify the customized EtherType value that must be
used when you select User Value from the EtherType Key menu.
This value must be compared against the information in an Ethernet frame. The valid range
of values is 0x0600 to 0xFFFF.
17. In the Source MAC field, specify the source MAC address that must be compared against
the information in an Ethernet frame.
The valid format is xx:xx:xx:xx:xx:xx.
18. In the Source MAC Mask field, specify the source MAC address mask that must be
compared against the information in an Ethernet frame.
The valid format is xx:xx:xx:xx:xx:xx.
19. In the VLAN field, specify the VLAN ID that must be compared against the information in an
Ethernet frame.
The valid range of values is 1 to 4093. Either VLAN range or VLAN can be configured.
20. From the Logging menu, select whether to enable or disable logging.
When set to Enable, logging is enabled for this ACL rule (subject to resource availability
on the switch). If the access list trap flag is also enabled, periodic traps are generated,
indicating the number of times the rule was evoked during the report interval. A fixed